New
Arrivals/Restock
DC 6-60V 400W BLDC Three Phase DC Brushless PWM Hall Electric Motor Controller Driver Board
5.0 (140 items)
Limited Time SaleUntil the end
22
10
20
US$7.61 cheaper than the new price!!
Free shipping for purchases over $99 ( Details )
Free cash-on-delivery fees for purchases over $99
Free cash-on-delivery fees for purchases over $99
See all stores
Please note that the sales price and tax displayed may differ between online and in-store. Also, the product may be out of stock in-store.
Used US$5.08
Product details
| Management number | 234209237 | Release Date | 2026/06/27 | List Price | US$5.08 | Model Number | 234209237 | ||
|---|---|---|---|---|---|---|---|---|---|
| Category | |||||||||
- Product Information: voltage 6-60V, high power 400W, Maximum current: rated 16A peak 20A,support PLC 0-5V analog control, support PWM control, amplitude 2.5-5V, note: this driver is only suitable for DC brushless Hall with an electrical angle of 120 degrees motor.
- There are 5 Hall wires on the brushless motor, two of which are Hall power wires. The three Hall signal wires must be distinguished, especially the power wires must not be mistaken. The order on the board must match the order of the three-phase wires on the motor driver board to work properly. If the three hall signal wires run smoothly, the low-speed start is smooth and the torque is large.
- Note: If you don't know the definition of Hall wire, please use low current and low voltage to test the first wiring tester, change the sequence of hall wire until normal operation, and then turn on high current and high voltage after confirming, otherwise there is Risk of damage to the driver board. At the same time, pay attention to the insulation of the wiring head when wiring.
- Features:MA MB MC phase line output is connected to the motor, 5V GND main board comes with 5V power supply, VCC GND main power supply, SC speed pulse signal output, DIR direction control forward and reverse control interface, STOP stop stop control interface, BRAKE brake control, brake control interface , speed control speed control signal input, Ha Hb Hc +5V GND Hall signal power supply input interface, generally motors with Hall have corresponding 5 wires.
- [Satisfactory Service]: We Provide 24-hour online service,If you encounter any problems, Please email SELLER SUPPORT (Not Amazon support), we will give you a perfect solution.
Bestseller ranking
HART Multitools
Customers who viewed this product also viewed
Motor Speed Controllers
Correction of product information
If you notice any omissions or errors in the product information on this page, please use the correction request form below.
Correction Request Form