EarthQuaker Devices Afterneath Enhanced Otherworldly Reverberator Pedal

<p>The Afterneath generates a swarm of short digital delays which may be used to create wild and cavernous reverbs, or scattered, short, rhythmic delays with bizarre characteristics. </p><h3>Flexi-Switch Technology</h3><p>This device features Flexi-Switch Technology. This electronic switching style allows you to simultaneously use momentary and latching style switching. For standard latching operation, tap the footswitch once to activate the effect and then tap again to bypass. For momentary operation, hold the footswitch down for as long as you’d like to use the effect. Once you release the switch, the effect will be bypassed. The Afterneath uses electronic buffered bypass, it requires power to pass signal and the buffer is always active. You may experience a pop the first time the Afterneath is switched on after power-up.</p><h3>Tails / No Tails Switching</h3><p>The Afterneath is factory set in tails mode. This means that the wet signal will naturally decay and slowly fade to silence after the effect is switched off.</p><h3>Expression Jack</h3><p>This is an expression pedal control jack for the Drag. The Afterneath requires an expression pedal with a value of 50k. While it will work with a standard 10k expression pedal, a 50k expression pedal will allow you to access the full range of each mode.</p>

• Flexi-Switch Technology: This device features Flexi-Switch Technology. This electronic switching style allows you to simultaneously use momentary and latching style switching
• Short Digital Delays: The Afterneath generates a swarm of short digital delays which may be used to create wild and cavernous reverbs, or scattered, short, rhythmic delays with bizarre characteristics
• Tails / No Tails Switching: The Afterneath is factory set in tails mode. This means that the wet signal will naturally decay and slowly fade to silence after the effect is switched off
• Expression Jack: This is an expression pedal control jack for the Drag. The Afterneath requires an expression pedal with a value of 50k. While it will work with a standard 10k expression pedal, a 50k expression pedal will allow you to access the full range of each mode
• Power: This device takes a standard 9 volt DC power supply with a 2.1mm negative center barrel