Jumper Starter Adapter for Milwaukee 18V M18 Batteries 12V Portable Jumper Cables kit,Automotive Booster Cable Adapter(Battery not Included)

(Battery not included)

• [Compatible with Milwaukee 18V M18 Battery]--Can be charged for Milwaukee 18V M18 Battery 48-11-1815, 48-11-1828, 48-11-1840,The starter adapter has a system to avoid short-circuit settings, the shorter the line the safer, rest assured that use!The longer the cable, the higher the R, and the risk of short circuit.
• [Up to 3.5L Gas or 6.5L Diesel Engines]--To use Jump Starter, first plug jumper cable adapter into your Mil.waukee 18V battery tightly, then attach the red battery clamp to the vehicle’s positive terminal (+) and the black clamp to the negative terminal (-). Next, Start the car and then remove the clamps.
• 1, connected to the 18V/20V battery, green light, connected to the car battery positive and negative (limited to 12V battery car) 2, when the starter light is green, start the car (or wait for charging for about 3-5 minutes).① connected to the battery green light is flashing: charging; ② red light is flashing: the battery power is not enough, please replace the battery;③ red and green light is on: connected to the battery positive and negative connection reversed
• 3、After the car starts, please remove the starter from the car battery, let the car engine continue to run, after using, please remove the battery from the starter.
• [Easy to use]-- only need to move the power adapter into the groove, then push converter and make sure it has locked the battery.For you to drive the outdoor travel camping work protection（Battery not included）