Red Head ITW 1/4 X 2-3/4" HWH 410 ss Buildex Tapcon Stainless Steel Concrete Anchors

ApplicationsThe anchor is made from 410 Stainless Steel, and is Silver Climaseal Coated. This anchor is designed for use in Concrete, Block, and Brick.EnvironmentThe anchor is designed for use in a Moist environment.Head Style The anchor is a Hex Washer head and is designed to allow the head to sit on top of the surface of the item being attached.Hole Diameter/Bit DiameterThe anchor requires a 3/16" hole to be drilled in the base material (Concrete, Block, and Brick). The hole should be drilled with carbide tipped bit that meets ANSI standards and used in a hammer drill.Driver RequiredA 5/16" is required for driving the anchor into the base material.Diameter of Anchor The diameter of the anchor is 1/4".Length Anchor The length of the anchor is 2-3/4"Thread LengthThe length of the threads on the anchor is 1-3/4" in length.Minimum EmbedmentThe minimum anchor embedment into the concrete is 1". Therefore, the anchor must be installed so that a minimum of 1" of the anchor is embedded into the concrete.Maximum Fixture ThicknessThe maximum fixture thickness or the maximum thickness of the material being fastened for a anchor is 1-3/4". This will ensure that t(more...)

• BIT INCLUDED IN EACH BOX-Proper bit equals improved holding values and reduced cost
• FLAT PHILLIPS HEAD--Can be driven with Phillips Screw Driver
• SELF-TAPPING-Taps threads directly into masonry and requires no other anchor
• DIAMOND POINT-Easier to drive the screw to save time
• We carry a wide variety of product ranging from bolts, nuts and washers to threaded rod, pipe flashings and connectors. Visit our Amazon storefront to view all items.